neabot NoMo N2 Guide De L'utilisateur page 16

Get Started
8. Cleaning
On/Off/Pause
• Press and hold the button
to a steady blue light after 5 seconds, and then the robot enters the standby state; Short press the button
and hold the button
• When the robot is still, press the button
will go out after 5 seconds.
• In the process of cleaning, short press the button
• If the robot is still and has not operated for more than 20 minutes, it will enter the hibernate state. In the hibernate state, you
can give any button a brief press to wake up the machine.
Note: During charging, the robot cannot be turned off.
Automatic Recharge/Manual Recharge
• When the battery is low during cleaning, or when the
cleaning is finished, the robot will automatically recharge.
• During cleaning, short press the button
will return to the self-emptying dustbin to recharge.
Add Water to the Water Tank or Clean the Mop
Cloth Mid Way
• Short press this button
the mopping module, after adding water or cleaning the
mop, reinstall the mopping module, short press this button
again to continue cleaning.
for 3 seconds to turn on the machine; The power indicator flashes slowly in white, and changes
for 3 seconds to start the spot cleaning.
for 3 seconds to turn off the machine. The power indicator flashes blue quickly and
, then the robot
, the robot will pause, remove
, then the robot will pause.
Set the Cleaning Mode
• The machine is the standard mode by default; After it is
connected with App, you can select more modes in the App.
Failure State
• When the robot is abnormal. it will give a voice prompt and the
power indicator will blink in orange. Please refer to "Trouble-
shooting" for solutions.
• When there is no operation for 10 minutes under the failure
state, the robot will hibernate automatically.
• When the machine runs abnormally, the power indicator will
blink in orange, and the machine does when some faults occur.
Please refer to the table below for a solution.
13
to clean all; or press