The Weighing Hand Pallet Truck; Taking The System Into Operation; Power Supply - Ravas 1100 Manuel D'utilisation

1. The weighing Hand Pallet Truck
1.1. Taking the system into operation
To activate the weighing system, turn it on using the on/off () key on the terminal.
After 3 to 5 minutes the electronics and load cells have reached the operational
temperature. Before this, inaccuracies of up to ca. 0.3% may occur.
It is recommended not to lift loads before the zero‐point correction has been executed.
1.2. Power supply
The power supply to the system takes place through an exchangeable battery pack. Note:
For legal for trade systems the power supply to the system takes place through a fix
mounted battery.
With a completely charged battery the total weighing time is about 35 hours (on a system
without a printer).
When the voltage level of the battery is running low, the display will show
"LO‐BA" indication is shown for 1 or 2 minutes, the weighing system switches off
automatically. It is strongly recommended to charge the empty battery directly with the
supplied charger.
In order to maximize the lifetime of the battery, follow the charging instructions below
precisely:
1. Insert the battery into the charger module. Note: For legal for trade systems connect
the charger cable to the system
2. Plug‐in the charger adaptor plug, into mains voltage 220‐240VDC. The red LED on the
charger adaptor is lit to indicate that the charger is charging the battery. When
charging, it is necessary to charge the battery for at least 6 hours. This will prevent
loss of battery capacity.
3. An empty battery will be fully charged after approximately 6 hours. When the red
LED turns off, the battery is fully charged. It is not possible to overload the battery
because the charger switches off automatically.
4. De‐connect the charger adaptor plug from the 220‐240VDC mains voltage.
5. After taking out the charger adaptor plug, directly remove the battery from the
charger module. Note: For legal for trade systems directly remove the charging cable
from the system after removing the adapter from the charger.
6. For charging a next battery, start at step 1 again.
If you use the system in shift work or if the system has a built‐in printer, it is recommended
to purchase a supplementary battery pack.
‐ 4 ‐
. When the