Mechanical Installation - Renkforce HEADUNiT CD-3308 Notice D'emploi

46 ENGLISH
Version 11/06

Mechanical Installation

In most vehicles the producers plan an installation cut-out for the car radio. The choice
of the location depends on safety aspects. Therefore we recommend that you actually
install the radio in this place.
The CD tuner requires a DIN installation cut-out with the dimensions 182x53mm; these
dimensions are standardized and usually the vehicle manufacturers keep to them.
Should there be no cut-out, please ask your car dealer about the correct place of
installation for your car radio.
Please select the place of installation carefully so that the CD tuner
neither influences the driver's activity nor distracts him from the
traffic.
Only use the supplied installation material to guarantee a safe
installation.
Any changes in the vehicle that become necessary for the
installation of the CD tuner or other components, must be carried
out in such a way that neither the traffic security nor the stability of
the car are affected. In many vehicles the operating permit expires
when you just saw out a piece of metal.
Since the CD tuner creates heat during operation, the place of
installation must be heat-resistant.
Before you bore the fasting holes, make sure that you do not hit any
electrical cables, brake lines, the fuel tank etc.
When using tools for the installation of your car HiFi components,
please observe the safety instructions of the respective
manufacturer.
When you install your HiFi system, please also consider the risk of
injury that may be caused by parts torn away in case of an accident.
Therefore you should securely fasten every part in a place where it
cannot become dangerous for the passengers of the car.
Before you install the system, check the depth of the installation recess.
Installation Position
The angle of installation to the horizontal must be under 20°. A CD tuner that is inclined
too much, may cause problems when playing CDs.
All manuals and user guides at all-guides.com