What To Do If It Goes Wrong - Hoover air Lift LIGHT Mode D'emploi

What to do if it goes wrong

Any other servicing should be done by an authorized service representative. If appliance
is not working as it should, has been dropped, damaged, left outdoors, or dropped into
water, take it to a service center prior to continuing use.
WARNING: To reduce the risk of personal injury - unplug before cleaning or servicing.
Problem
There is an
accessory
missing
Why does my
vacuum cleaner have
no power?
Why won't the
vacuum cleaner
pick up?
Why isn't my
brushroll rotating?
Why is dust
escaping
from the vacuum?
Solution
• Check the 'This pack contains' panel on the box to make sure the
part is included with your vacuum cleaner.
• The plug may not be fully pushed into the electrical socket.
• The motor thermostat may have tripped. If this has happened, unplug
the vacuum cleaner. Remove and empty the dirt cup and check the hose
for blockages. Clean the filters and allow the vacuum cleaner to cool for
approximately 1 hour (if you have washed the filters you will need to wait
24 hours for the filters to fully dry before putting them back into the vacuum
cleaner). If this doesn't work, there may be no voltage in the wall plug.
Check fuse or tripped breaker, replace fuse or reset breaker in home.
• The dirt cup may not be fitted correctly, remove the dirt cup and
re-attach making sure it is clicked firmly into place.
• The dirt cup may be blocked, empty the dirt cup and clean the filters.
Go to 'Taking care of your machine'.
• There may be a blockage in the hose. Check and clear any blockages.
Go to 'Let's talk technical'.
• The brushroll may not be turning.
Go to 'Why isn't my brushroll rotating?' below.
• If the accessory/tool will not pick up, check and clear any blockages.
Go to 'Let's talk technical'.
• The brushroll may not be turned on. Go to 'Getting started'.
• The vacuum cleaner may not be reclined. Go to 'Getting started'.
• The lift off canister may not be correctly assembled to the spine and nozzle.
Go to 'Getting started'.
• The brushroll may be obstructed. Go to 'Let's talk technical'.
• The brushroll may need resetting. Go to 'Let's talk technical'.
• The belt may be broken. Go to 'Let's talk technical'.
• The filters may not be correctly fitted. Go to 'Taking care of your machine'.
• The dirt cup may be full or blocked. Go to 'Taking care of your machine'.
• The filters may need cleaning. Go to 'Taking care of your machine'.
• There may be a blockage in the hose. Go to 'Let's talk technical'.