Hoover air Lift LIGHT Mode D'emploi page 15

IMPORTANT: Rotate brushroll manually to make sure the belt is properly installed. Vacuum is
equipped with an automatic brushroll shut-off in event of overload or jam. Check for obstructions
in the brushroll area and remove any obstructions.
Cleaning the brushroll
CAUTION: To reduce the risk of injury from moving parts - unplug before servicing.
Slide belt over motor
shaft with the lettering
on the outside of the
belt.
LUBRICATION NOT REQUIRED
The motor and brushroll are
equipped with bearings which
contain sufficient lubrication for
their lifetime. The addition of
lubricant could cause damage.
Do not add lubricant to motor
or brushroll.
See us do it:
Hoover.com/video-instruction-guide
Slide other end of
belt around end of
brushroll.
Let's talk technical
With belt in place,
slide brushroll into
nozzle making sure
that the brushroll end
caps are in the correct
orientation.
For additional maintenance required for
belt or brushroll please contact a HOOVER®
service provider at 1-800-944-9200.
Replace the bottom
plate and reinstall the
6 screws as shown.