Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Turn on/off message edit
You can edit the turn on/off message and store it in memory.
Following four messages (factory set) can be edit with 8 char-
acters each.
Turn-on message
• MESSAGE 1 : HELLO
• MESSAGE 2 : WELCOME
Turn-off message
• MESSAGE 3 : SEE YOU
• MESSAGE 4 : GOOD-BYE
1.
Repeatedly press the
to display the " MESSAGE "
DISP
on the display window.
2.
Rotate the dial to select the desired message you want
to edit.
MESSAGE1
MESSAGE2
MESSAGE3
SAGE4
3.
Press the
, then enter the character.
MUTE / SENS
A. Rotate the dial in a clockwise direction to select the
desired characters.
∗
( A
B
C
. . . Z
<
>
0 1 2 3...9 " "Space )
B. Press the
to move the flashing cursor to
TUN/TRK
the next position. If you press
cursor moves to the left.
C. Repeat steps A. and B. to complete entering the en-
tire message 8 characters max.
Tip
To erase/correct a message, press the
2 seconds to clear the character and re-enter.
4.
Press the
to store the message.
MUTE / SENS
The new message flashes.
5.
To return to the normal radio reception, Press
Note
If you make no button input or dial operation in 20 seconds,
the message edit mode will turn off automatically.
Key Largo (Eng) p.1-13
Erasing the turn on/off message
You can erase the turn on/off message if so desired.
1.
Repeatedly press the
rotate the dial to select the message you want to erase.
2.
Press the
MUTE / SENS
The message flashing.
3.
Press the
DISP
Repeat steps 1. and 3. if you want to erase other mes-
sage.
4.
To return to the normal radio reception, Press
Demonstration mode
The unit shows a demonstration of each function.
MES-
When a demonstration is finished, it begins again after 10
seconds, and this is repeated.
1.
Press the
PWR
2.
Press the
DISP
'
+
-
/
seconds to activate the demonstration mode.
'
Press both button again for more than 2 seconds to can-
cel this mode.
, the flashing
TUN/ TRK
for more than
DISP
.
DISP
7
to display the MESSAGE, then
DISP
.
for more than 2 seconds.
.
DISP
to turn off the unit.
and
simultaneously for more than 2
1
6/19/00, 10:02 AM
CD Operations
Playing the CD player
Loading Discs
1.
Press the
and insert the disc.
OPEN
2.
Close the front panel.
Playback begins automatically.
'' LOADING '' indicator will flash in the display window.
Note
Make sure that the front panel is closed when playback be-
gins.
Playback with the front panel open causes the
unit to turn off automatically in about 10 min-
utes.
Label side up
! NEVER Insert a 3-inch CDs.
This unit is designed for playback of standard 5-inch CD's
only. Do not attempt to use 3-inch CD singles in this unit,
either with or without an adaptor, as damage to the player
and/or disc may occur.
Tips
• When a CD is loaded, the
on the display remains lit.
• During playback of a CD, the pie-shaped signal-strength
meter
spins.
E-7
Publicité
Table des Matières
Dépannage
