Kimberly-Clark PROFESSIONAL ICON 53696 Mode D'emploi page 2

Install Dispenser Bracket Install Bracket
Enclosed**
For push buttons and other available parts,
contact your sales representative.
Mount the toilet paper dispensers to be 7
inches (180 mm) minimum and 9 inches
(230 mm) maximum in front of the water
closet measured to the centerline of the
dispenser.
The outlet of the dispenser shall be
15 inches (380 mm) minimum and 48
inches (1220 mm) maximum above the
finished floor. For the ICON dispenser,
the center of the install bracket is the
center of the dispenser.
See the module installation manual for
the next installation steps.
1. Measure 32 ½ inches from the floor with
a tape measure to the bottom of the
mounting bracket. Make sure the built-in
level on the bracket reads level. Ensure
the required clearance space is free
of obstructions for proper dispenser
installation.
2. Carefully brace the mounting bracket in
place once it is properly located on the
wall and mark holes to drill.
3. Remove the bracket from the wall,
leaving just the four marked holes. Drill a
hole in each of the four marked locations
so anchors** can be inserted.
4. Tap in the four anchors in each drilled
hole so the bracket can be screwed to
the wall.
Tools Required:
7" - 9"
1.
6 ½" 17 cm
1 / " 1 / "
4 cm 4 cm
32 ½" 83 cm
3.
*Check for regional & local installing/
mounting requirements.
2.
4.