Description Of The Error Message System; Receipt Of Centrifuges To Repair; Transport And Storage - OHAUS Frontier FC5513 Manuel D'instructions

EN-20
6.2.2

Description of the error message system

The error message "error" (M11) is shown in the "Time/Prog" (A-4) display (See figure 36). Detailed information
about possible error messages are in "table 6: error messages" (See APPENDIX).
7.

RECEIPT OF CENTRIFUGES TO REPAIR

Health risk from contaminated equipment, rotors and accessories.
In case of returning the centrifuge for repairing to the manufacturer, please notice the following:
The centrifuge must be decontaminated and cleaned before the shipment for the protection of persons, environment
and material.
Decontamination certificate at goods return delivery (See APPENDIX)
We reserve the right to not accept contaminated centrifuges.
Further on all costs occurred for the cleaning and disinfection of the units will go to the debit of the customer's account.
8.

TRANSPORT AND STORAGE

8.1 Transport
Before transporting, take out the rotor.
Only transport the unit in the original packaging.
Use a transport aid for transporting over longer distances to fix the motor shaft.
General transportation
8.2 Storage
During storage of the centrifuge the following environmental conditions must be observed:
in transport packaging
Emergency
Lid Release
Figure. 35-1
M11
Air temperature rel. humidity
-25 to 60 ° C 10 to 75 %
Air temperature rel. Humidity
-25 to 55 °C 10 to 75 %
Figure. 35-2
A-4
Figure. 36
Air pressure
30 to 106 kPa
Air pressure
70 to 106 kPa
TM
Frontier Centrifuge FC5513
Figure. 35-3