Care And Cleaning - KitchenAid KSBC1B2 Mode D'emploi

CARE AND CLEANING

NOTE: Do not immerse the Blender base or cord in water. Do not use abrasive
cleansers or scouring pads to avoid scratching.
1
Fill half of the jar with warm water and add
1 or 2 drops of dish-washing liquid. Secure
the Lid and Ingredient Cap. Place the jar
on the base. Close the front cover.
3
Unplug before cleaning. Wipe the base
and the cord with a warm, damp cloth and
dry with a soft cloth.
NOTE: Handle must be removed from the front cover prior to cleaning by removing the
two screws inside the front cover.
SANITIZING THE BLENDER JAR
1. Remove all contents from the blender jar.
2. Fill ¾ of the jar with a sanitizing solution mix of 1.5 tsp. (7.4 mL) institutional or
household bleach in 60 oz (1.75 L) water. Place the lid, and securely place the blender
jar onto the blender base.
3. Run the blender on the High Speed setting for 35 seconds.
4. Turn off to let the sanitizing mix sit in the blender jar for an additional 2 minutes.
5. Pour out the solution. Do not rinse the blender jar.
6. Place the lid on the blender jar. Make sure the empty blender jar is fully in place on
the blender base. Run the empty Blender for an additional 10 seconds. Do not rinse
the jar after sanitizing.
7. Allow the blender jar to air dry.
8
W11341965A.indd 8
2
Rotate the control dial to 50 seconds.
Flip the START/STOP toggle switch up or
down. When the timer finishes, remove
and empty contents and rinse with warm
water and dry thoroughly.
4
Wash the blender jar, jar pad, lid, front
cover, back cover, handle, and ingredient
cap by hand with a damp cloth and warm
soapy water; rinse with warm water, and
dry with a soft cloth.
16/05/2019 14:20:27