After Installation - LG OLED55G2 Serie Manuel D'utilisation

For installation on wood stud
Use the Ø 4 mm drill bit for wood to drill holes with the depth of 76 mm.
(Clean the drilled hole.)
Without using the wall mounting anchor, fasten the wall mounting screw
directly to the wood stud.

After Installation

• When connecting additional cables from the sides, we recommend
holding the centre of the TV horizontally or vertically and pulling the
product to make sure there is sufficient distance from the wall before
connecting.
• When connecting additional cables from the bottom, we recommend
releasing the TV from the wall mount before connecting.
(For example)
• Use cable management systems to arrange the cables at the bottom of
the TV as shown below. Cable managements are not provided with the
product, so purchase them separately.
• After installing the product, be sure to use it adhered to the wall.
- Using the product while it is not adhered to the wall may damage or
shake the product.
• Do not use a sharp object when you detached the cable cover. This could
damage the cable or the cabinet. It may also cause personal harm.
Drywall
76 mm
Wood stud
Antenna/Cable
Connect the TV to a wall antenna socket with an RF cable (75 Ω).
• Use a signal splitter to use more than 2 TVs.
• If the image quality is poor, install a signal amplifier properly to improve
the image quality.
• If the image quality is poor with an antenna connected, try to realign the
antenna in the correct direction.
• An antenna cable and converter are not supplied.
• For a location that is not supported with Ultra HD broadcasting, this TV
cannot receive Ultra HD broadcasts directly.
Satellite dish
Connect the TV to a satellite dish to a satellite socket with a satellite RF cable
(75 Ω). (Depending on model)
7