Klarstein Espressionata Gusto Mode D'emploi page 34

EN
34
2 Remove the water tank.
3 Fill the water tank to maximum level with a mixture of water and a household
decalcifier in the proportion that is mentioned in the instructions written on the label
of the decalcify. If you use citric acid instead of a decalcifier, mix the water with
citric acid in the proportion of 100:3 (water:citric acid)
4 Replace the water tank.
5 Make sure that the steam knob is at position 0 and the button
accidental scalding.
6 Place the metal funnel with the steel mesh in the metal funnel holder and place a
heat-resistant cup below the steam tube.
7 Press the button to turn on the appliance.
8 Press the button . The appliance will start pumping water from the tank through
the filter.
When the water starts flowing out of the outlet, press the button
9
10 Wait until the indicator WATER lights.
1 1 Now press the button
12 Press the button again to stop.
13 Empty the vessel into the sink. Do not drink this liquid or use it for any other purpose.
14 Wait for 5 seconds and press the button
15 Wait until the indicator STEAM lights.
16 Turn the steam knob slowly and counter-clockwise and produce steam for about
2 minutes.
17 Turn the steam knob back to the position 0.
18 Press the button to turn off the appliance.
19 Leave the decalcifyer-mixture in the appliance for at least 15 minutes.
Repeat the steps of 7-18 at least 3 times.
Rinsing
1 Press the button to turn off the appliance.
2 Make sure that the steam knob is at position 0 and the button
accidental scalding.
Check if the water tank needs to be filled. The water level must not exceed the MAX
3
mark. Refill the tank if necessary and place it into the appliance.
4 Place the metal funnel together with the steel mesh in the metal funnel holder and
place a heat-resistant cup below the steam tube.
5 Press the button to turn on the appliance.
6 Press the button . The appliance will start pumping water from the tank through
the filter.
7 When the water starts flowing out of the outlet, press the button
8 Wait until the indicator WATER lights.
9 Press the button and let the water run until the water tank is empty.
to prepare a cup full of the descaling mixture.
.
is off to prevent
again to stop.
is off to prevent
again to stop.