Hotpoint Ariston SI E40 BA0 Mode D'emploi page 25

Selecting the temperature
and adjusting the steam (B
1. Connect the plug of the appliance into a
grounded socket (220-240V).
2. Use the temperature control (4b) to select the
desired temperature. If you go from a lower
temperature to a higher temperature, the
temperature indicator light (4c) light up until the
selected temperature is reached.
3. When the iron reaches the set temperature, an
acoustic signal is emitted and the temperature
indicator light goes off.
4. We recommend to check the garment label
in order to identify the fabric type. In case of
doubts, it is recommended not to use the spray
function and iron a hidden corner in order to
determine the most appropriate temperature
and avoid damaging the fabric. In case of very
delicate fabrics, such as silk, wool, and synthetic
materials, iron the garment inside out to prevent
shiny marks. Start ironing the garments that
require a lower temperature, such as synthetic
fabrics.
Fabrics with this symbol on the label
must not be ironed.
GARMENT
FABRIC TYPE
LABEL
synthetic
silk
mixed cotton
wool
mixed wool
cotton
linen
jeans
5. Select the steam level with the steam regulator
(3) or move it to Off to iron without steam. When
steam ironing, make sure that the water level in
the reservoir is at least ¼.
USE
The iron starts producing steam as soon as
it reaches the set temperature.
If the water in the reservoir is finished, it
may be necessary to press the shot of
All manuals and user guides at all-guides.com
)
2
TEMPERATURE STEAM
INDICATION INDICATION
MIN
LINEN
LCD
steam button several times to (re)activate the
pump, after filling the water reservoir again.
Ironing without steam (C
1. Set the steam regulator (3) to Off (=no steam).
2. Select the recommended ironing temperature
with the temperature buttons +/- (4a) (see step B
and chapter "Using the iron", section "Selecting
the temperature and adjusting the steam").
Steam ironing (D )
1
1. Check that the water level in the reservoir is
higher than ¼.
2. Select the appropriate steam with the steam
regulator (3) and the recommended ironing
temperature with the temperature buttons +/-
(4a) (see step B and chapter "Using the iron",
1
section "Selecting the temperature and adjusting
the steam").
Ironing with shot of steam (E
The shot of steam function allows you to eliminate
persistent wrinkles. You can use this function both in
no-steam and steam ironing mode.
1. Check that the water level in the reservoir is
higher than ¼.
2. Select the recommended ironing temperature
with the temperature buttons +/- (4a) (see step B
and chapter "Using the iron", section "Selecting
the temperature and adjusting the steam").
3. Press the shot of steam button (1) to obtain
an extra steam flow when ironing. If the shot
of steam function has not been used for some
time, it may be necessary to press the button
repeatedly to activate the pump.
USE
Ironing without steam (C
1. Set the steam regulator (3) to Off (=no steam).
2. Select the recommended ironing temperature
with the temperature control (4b) (see step B
and chapter "Using the iron", section "Selecting
the temperature and adjusting the steam").
Steam ironing (D )
2
1. Check that the water level in the reservoir is
higher than ¼.
2. Select the appropriate steam with the steam
regulator (3) and the recommended ironing
temperature with the temperature selector
(4b) (see step B and chapter "Using the iron",
2
it en
)
1
1
)
1
1
)
2
2
25