Whirlpool WRS321SDHZ Manuel D'utilisation page 25

4. Disconnect the wiring, located behind the base grille on the
freezer door side as shown below.
A. P–Clamp
B. Routing Plate
C. Electrical Housing
On models with the ice storage bin on the door:
NOTE: There are two wiring bundles that run underneath the
freezer - a large bundle with a large grommet and two white
plugs at the end, and a small bundle with a small grommet and
one yellow plug at the end.
� Remove the P-clamp using a 1/4" hex-head socket
wrench. Remove the small wiring bundle from the P-clamp.
� Remove the wiring clip using a 1/4" hex-head socket
wrench.
� Pull the electrical housing out from under the refrigerator.
Disconnect the wiring plugs from the housing.
� Gently pull the large wiring bundle (with two white plugs)
through the routing plate.
On models with the ice storage bin inside the freezer:
NOTE: The wiring configuration is simpler than what is shown
in the above graphic. There is only one wiring bundle with one
wiring plug, and there is not a routing plate.
� Remove the wiring clip using a 1/4" hex-head socket
wrench.
� Pull the electrical housing out from under the refrigerator.
Disconnect the wiring plugs from the housing.
5. Close both doors and keep them closed until you are ready to
lift them free from the cabinet.
6. Depending on your model, use a 3/16" hex key or a TORX
T30 screwdriver to remove the top-left hinge screws as shown
below.
IMPORTANT: Do not remove either screw A. Hold the door
while hinge is being removed.
A. Do not remove these screws.
D. Wiring Clip
E. Grommets
F. Wiring Plugs
WARNING
Excessive Weight Hazard
Use two or more people to lift the appliance door.
Failure to do so can result in back or other injury.
7. Lift freezer door straight up off bottom hinge as shown below.
The water tubing and wiring remain attached to the freezer
door and pull through the bottom-left hinge.
NOTE: This may require two people, one to lift the door and
another to feed the water tubing and wiring into the bottom
hinge pin.
On models with the ice storage bin on the door:
� Be sure the hole in the hinge is clear of obstructions; then
gently pull one water tube through the hinge. (Avoid
kinking the tube.) Next, gently pull the other water tube
through the hinge, again avoiding kinks. Finally, gently pull
the wiring bundle (including the grommet and wiring plugs)
through the hinge.
On models with the ice storage bin inside the freezer:
� Be sure the hole in the hinge is clear of obstructions; then
gently pull the water tube through the hinge. (Avoid kinking
the tube.) Next, gently pull the wiring bundle (including the
grommet and wiring plug) through the hinge.
IMPORTANT: Rest the door on its side on a soft, clean
surface, such as a towel, blanket, or piece of cardboard. This
will help to avoid scratching or damaging the door, water
tubing, and wiring.
8. Use a 3/16" hex key to remove the top-right hinge screws as
shown below.
A. Do Not Remove Screws
IMPORTANT: Do not remove either screw A.
9. Lift the refrigerator door straight up off bottom hinge.
IMPORTANT: Rest the door on its side on a soft, clean
surface, such as a towel, blanket, or piece of cardboard. This
will help to avoid scratching or damaging the door.
25