EURAPO OMNIBUS 360 Série Manuel D'utilisation Et Installation page 43

Cables coming from a junction box in the wall (on-wall version)
Fix the plastic bottom panel
Insert the cables through the central back opening or the side slots of the back plastic
of the console.
Fix the back plastic
2
Make the electrical connections by using the 4-pole connector supplied with the console,
by respecting polarity (Fig. 3).
Install the console by fixing the front plastic
Cables coming from an external cable duct on the wall (on-wall version)
Drill the plastic bottom panel
Once the cables are inside the bottom panel
or the side slots of the back plastic
Fix the back plastic
2
Make the electrical connections by using the 4-pole connector supplied with the console,
by respecting polarity (Fig. 3).
Install the console by fixing the front plastic
3
Fig. 5
to the wall.
3
to the bottom panel
to let the wires in. Fix the plastic bottom panel
3
of the console.
2
to the bottom panel
.
3
: make a little pressure to interlock it.
1
, insert them through the central back opening
3
.
3
: make a little pressure to interlock it.
1
2
2
to the wall.
3
1
43 /92
EN