EURAPO OMNIBUS 360 Série Manuel D'utilisation Et Installation page 35

Name Description
C1 Value read by the SE temperature sensor inside the console [°C].
C2 Value read by the AS room temperature sensor [°C].
C3 Value read by the WS water temperature sensor [°C].
C4 Value read by the CS air outlet temperature sensor [°C].
C5 Value read by the temperature sensor connected to the multipurpose terminals [°C].
C6 Room temperature value given by Modbus [°C].
C7 Lasting time for the room temperature value given by Modbus [seconds].
C8 Voltage given to the EC motor [V].
C9 Operating status of the AC motor.
C10 Status of the modulating heating valve.
C11 Status of the modulating cooling valve.
C12 Status of the ON/OFF heating valve.
C13 Status of the ON/OFF cooling valve.
C14 Status of the electric heater output.
C15 Status of the multipurpose input.
C16 Status of the pressure switch/condensate pump alarm input.
C17 Status of the window contact input.
C18 Status of the EC motor alarm input.
C19 Working operation period for dirty filter indication [hours].
C20 Modbus address of the slave unit with alarm.
C21 Type of alarm of the slave unit.
C22 Setup number.
C23 CRC (factory code).
EN
35 /92