All manuals and user guides at all-guides.com
USE
Button
Function
A
Turns the suction motor on and off at the last
speed used.
B
Decreases the operating speed.
C
Increases the operating speed.
D
Activates intensive speed from any other speed,
even with the motor stopped. Intensive speed is
timed to run for 10 minutes, after which the sys-
tem will return to the speed that was set previ-
ously. Suitable to deal with the highest level of
cooking fumes.
E
Starts the motor at a speed that allows recircula-
tion of 100 m3/h for 10 minutes in every hour;
after which the motor stops.
When the filters alarm is triggered, the alarm can
be reset by pressing and holding this button for
approximately 3 seconds. These indications are
only visible when the motor is turned off.
F
Activates automatic shutdown with a 30' delay.
Suitable to complete elimination of residual
odours. It can be activated from any position, and
is deactivated by pressing the button or turning the
motor off.
G
Turns the lighting system (overhead spotlights) on
and off. If pressed and held for 2 seconds it turns
the side lights (Neon strips) on and off.
H
Turns the low intensity lighting system (overhead
spotlights) on and off.
EN
A
D
B
C
E
F
G
H
Control panel
Display
Displays the speed setting
Displays HI and the spot at the bottom
right flashes once a second.
Displays 24 and the spot at the bottom
right flashes, while the motor is running.
When the procedure has been completed,
the indication previously displayed will
turn off:
FF indicates the need to wash the metal
grease filters. The alarm is triggered af-
ter the Hood has been operating for 100
actual working hours.
EF indicates the need to change the acti-
vated charcoal filters, and also to wash
the metal grease filters. The alarm is
triggered after the Hood has been operat-
ing for 200 actual working hours.
Alternately displays the working speed
and the time remaining until the hood is
turned off. The spot at the bottom right
flashes.
1
11
1