Remote Functions - Nicols PAR LED 73 RGB Notice D'utilisation

IR REMOTE OPERATION USE (optional : reference REMOTE TPL)
MODE

REMOTE FUNCTIONS

Blackout
AUTO AR
SPR + numbers
BUILT-IN
PROGRAMS
FL( flash)
STATIC
COLORS R / G / B + numbers
(Pr.01)
R + +/- buttons
DIMMING
G + +/- buttons
B + +/- buttons
SLAVE MODE SL
SA
SOUND-
ACTIVE MODE +/- buttons
D
DMX MODE
S + 3 numbers
NOTE :

To restore factory settings without remote, press on MODE + SETUP when turning on the power of the fixture
All manuals and user guides at all-guides.com
Turn on / off the lights
AUTO mode (built-in programs from Pr.02 to Pr.07)
Selection of built-in program : press on SPR (LED light will
comeyellow then turns off), then press on a number from 2 to 7.
Press on + or – to adjust running speed of the program.
Press on FL to adjust strobe speed with + or - buttons
Press on R, then a number from 0 to 9 to select a color (0 : white,
1 : red, 2 : orange, 3 : jaune, 4 : vert, 5 : cyan, 6 : blue, 7 :purple, 8 :
pink, 9 : amber)
Press on R, then buttons + or – to adjust the brightness of red. Light
will blink once the brightness is at its maximum or minimum.
Press on G, then buttons + or – to adjust the brightness of green.
Light will blink once the brightness is at its maximum or minimum.
Press on B, then buttons + or – to adjust the brightness of blue.
Light will blink once the brightness is at its maximum or minimum.
To select Slave Mode
To select Sound-Active mode
In Sound-Active Mode, use + or – buttons to adjust the sound
sensitivity
To select DMX mode
To set up a DMX address, press on S. The current adress will show
on the display. Press on the corresponding 3 numbers. The new
address is saved once the display blink 3 times.
INSTRUCTION