Maintenance Et Entretien - Quadra-Fire DISCOVERY-I Manuel Du Propriétaire

Discovery I
3

Maintenance et entretien

A. Quick Reference Maintenance Guide
When properly maintained, your fireplace will give you many years
of trouble-free service. Contact your dealer to answer questions
regarding proper operation, troubleshooting and service for your
appliance. Visit www.quadrafire.com/owner-resources
basic troubleshooting, FAQs, use & care videos.
Baffle & Blanket
Isolant
Déflecteur
Optional Blower
Chimney System
Firebrick & Ash Removal
Door & Glass Assemblies
Door Handle
Section transversale de la porte
Verrou à came (exemple)
Contre-écrou
Rondelles
d'espacement
Clé carrée
18
to view
Frequency
MONTHLY or
after every cord
of wood
YEARLY
or
After Every
4 Cords of
Wood
EVERY 2
MONTHS
or
After Every
4 Cords of
Wood
WEEKLY
or
After Every
25 Loads of
Wood
WEEKLY
or
After Every
25 Loads of
Wood
WEEKLY
or
After Every
25 Loads of
Poignée
à ressort
Poignée
Wood
de porte
These are generic drawings and may not represent your model.
CAUTION! Allow the appliance to completely cool down before
performing any cleaning or maintenance.
Start the first inspection after the first 2 months of use, or if
performance changes, and adjust your schedule accordingly.
Maintenance is required for safe operation and must be performed
to maintain your warranty.
Baffle and blanket placement is critical to heat output, efficiency
and overall life of the appliance. Make sure the baffle is pushed
all of the way to the back of the firebox and the blanket is laying
flat. Inspect baffle for cracks.
Vacuum the blower impellers.
The chimney and chimney cap must be inspected for soot and
creosote every two months during the burn season or more
frequency if chimney exceeds or is under 14-16 ft (4.3m-4.8m)
measured from bottom of appliance.
This will prevent pipe blockage, poor draft, and chimney fires.
Always burn dry wood to help prevent cap blockage and creosote
build-up.
Ashes must be cool before you can dispose of the ashes in a
non-combustible container.
Firebrick is designed to protect your firebox. After ashes are
removed, inspect the firebrick and replace firebricks that are
crumbling, cracked or broken.
Keep door and glass gasket in good shape to maintain good burn
times on a low burn setting. To test: place a dollar bill between
the appliance and door and then shut the door. If you can pull the
dollar out, remove one washer from door handle behind latch cam
and try again. If you can still pull it out, replace the door gasket.
Check the glass frame for loose screws to prevent air leakage.
Check glass for cracks.
Check the door latch for proper adjustment. This is very
important especially after the door rope has formed to the
appliance face.
Check door handle for smooth cam operation.
FC7039-173H
Task
13 Août, 2018