TZS First AUSTRIA FA-5582-4 Mode D'emploi page 2

INSTRUCTION MANUAL
IMPORTANT:
Read these instructions before use and retain for future reference.
MAINTENANCE:
Before carrying out any maintenance on your radiator, ensure that it is unplugged and
completely cold. Do not spray water onto the radiator. Wipe the casing with a soft, damp cloth.
Do not clean the radiator with detergents or abrasive cleaners.
WARNING: THIS APPLIANCE MUST BE EARTHED.
The wires in the mains lead are coloured in Accordance with the following code.
Blue: Neutral
Brown: Live
Green/Yellow: Earth
PLEASE READ THESE INSTRUCTION FULLY BEFORE USE.
PARTS IDENTIFICATION (see picture 1)
A) Radiator
B) Thermostat
C) Power buttons
D) Castor wheels
INTRODUCTION
The electric oil heater is manufactured to the highest specifications, utilising the latest
technology. It is finished to a high standard and is safe and easy to use. To get the best from
this product and prolong its life, please spare a few moment to read these user instructions.
FEATURES
Large heating surface provides uniform radiation.
Automatic temperature controller for adjusting and maintaining the desired room temperature.
Special high speed heat conducting oil is utilised.
Equipped with castor wheels for ease of movement.
IMPORTANT! SAFETY GUIDELINES
1) The radiator should always be kept upright.
2) Do not position your radiator near to flammable materials. Allow a distance of at least 50mm
between furniture, curtains, walls etc.
3) Do not position your radiator immediately under a socket outlet.
4) If the cord becomes worn it must be replaced by a qualified technician.
5) Do not lay the cords over the radiator when not in use.
6) Do not cover the radiator with anything.
7) The radiator must not be used in a bathroom or near a source of water.
8) It is normal for the radiator to make a noise when it is being used for the first time.
9) In case of problems with the radiator, please do not attempt any repairs, please contact the
retailer.
10) The oil used in this radiator is of a specification particular to this type of radiator and is
manufactured with a precisely measured quantity. Only approved agents must open up to
the oil container section to carry out repairs. Any oil leak must be reported to the retailer or
approved agent.
11) Check that your supply voltage is the same as that shown on the rating label and that the
socket is earthed.
M_5582-4_5584-4_v02.indd 2-3 M_5582-4_5584-4_v02.indd 2-3
All manuals and user guides at all-guides.com
2
FITTING THE WHEELS
(see diagrams a & b for guidance)
1) Turn the radiator upside down and rest on a soft surface to prevent scratching the radiator
housing.
2) Screw the wheel plate firmly onto the radiator, using the wire loops and wing nuts
provided.
3) Push the castor wheels onto the wheel pins on the plate until they "click" into place.
4) Turn the radiator back to its correct upright position.
OPERATING YOUR ELECTRIC OIL HEATER
Place the heater on the floor at least 90cm away from the wall and any other objects such as
furniture, curtains or plants.
(Make sure me power supply used corresponds to the one on the rating label)
With the thermostat in the "LOW" position and the power setting switches in the "0" position
plug the heater into the main power supply.
1. Room temperature can be adjusted using the thermostat simply turn the thermostat knob
clockwise to increase the temperature and anti-clockwise to decrease the temperature until
you reach the desired temperature.
2. The indicator light will on when the thermostat is "on".
3. Switch the heater to one of the following power settings: (see picture 2)
4. Turning the thermostat control clockwise will increase the "set" temperature.
5. Turning the thermostat anti-clockwise will decrease the "set" temperature.
6. Do not cover the heater at any time during operation There is a risk of fire if the heater is
covered
7. Once you have finished using your heater, turn the power switch to the "0" positions, and
turn the thermostat control switch to the "LOW" positions, and unplug from the mains
supply.
CLEANING YOUR ELECTRIC OIL HEATER
1. Always disconnect the heater from the mains supply before cleaning.
2. Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.
3. Do not use waxes or polishes as these may react with the heater and cause
discolouration.
STORING YOUR ELECTRIC OIL HEATER
1. Save the box for off season storage
2. Clean the heater following the cleaning instructions above.
3. Remove the wheel base assemblies.
4. Place the heater, and wheel assemblies in the original box, and store in a cool and dry
place
5. If you choose to store your heater fully assembled be sure to cover it to protect it from
dust.
SPECIFICATIONS
FA-5582-4: 9 fins; 220-240V • 50/60Hz • 1830-2200W
FA-5583-4: 11 fins; 220-240V • 50/60Hz • 2000-2400W
FA-5584-4: 13 fins; 220-240V • 50/60Hz • 2300-2730W
3
5/29/09 9:38:58 AM 5/29/09 9:38:58 AM