Baninni ROADTRIP Mode D'emploi page 20

MANUAL
Fitting the seat with the 3 point seatbelt.
STEP 1
STEP 4
Step 1. Place the child safety seat on the vehicle's sat ensuring it is firmly pressed
against the car seat backrest.
Step 2. Thread the car seat belt in through the seat belt route slot in the seat's
plastic backrest furthest from the car's seat belt buckle, and then out through the
other seat belt jroute slot and fasten it into the seat belt buckle.
Step 3. Check the webbing of the seat bel has not become twisted or tangled
and that the lap belt goed under the armrest and the diagonal belt under the
headrest belt guide then goes over the red belt guide on the side of the backrest.
Step 4. Place your knee on the base of the safety seat and grip the top pieve of
the seat belt webbing. pull the webbing upwards to tighten the seat belt.
Step 5. Finish tightening the webbing by pulling the diagonal strap upwards until
there is no slack and the seat is held firmly in place. Now you van strap your child
into the seat.
All manuals and user guides at all-guides.com
9-18kg
(ca 9months until 4years)
STEP 2
STEP 3
STEP 5