Publicité
Les langues disponibles
Les langues disponibles
S 3 2 8 4 :
8.
Output and direction of rotation are adjusted by turning the lever. Clockwise = F / Anti-
clockwise = R.
9.
Output can be adjusted in three stages for clockwise and one stage for anti-clockwise
direction using the lever.
S 3 2 8 1 / S 3 2 8 2 / S 3 2 8 3 :
8.
8.
The direction of rotation can be adjusted on the ratchet head.
Clockwise = F / Anti-clockwise = R.
S A F E T Y I N S T R U C T I O N S
1.
In the case of a drive square with bore hole, the socket must be secured using a steel pin and
rubber ring. If the drive square is fitted with a spring ring, this must be checked for sufficient
tension at regular intervals and replaced if necessary. A socket which is not secured as described
in the way described here can become loose from the tool and cause damage. For this reason,
never allow the pneumatic tool to rev up in idling gear if there is a socket on the drive.
2.
Only use sockets which are suitable for impact screwdrivers.
3.
The pneumatic tool should only be used for loosening / tightening screws. Damage
resulting from non-observance of these instructions, improper use or manipulation of
the tool is excluded from warranty claims. We reserve the right to make technical
changes.
4.
Those operating the pneumatic tools are not allowed to wear loose clothing and
must have long hair tied back. - ACCIDENT HAZARD
5.
Always wear ear protection, safety gloves and goggles.
6.
Check hose connections for a firm fit. Do not use any damaged pressure hoses.
Damage caused by non-observance of these operation instructions or by improper repairs is not
covered by our guarantee. We reserve the right to make changes in the interest of technical progress.
8
Publicité
