Fenton RP180 Serie Manuel D'instructions page 4

OVERVIEW
1. Lift Lever
Operate to lower or raise the tone-arm.
2. Autostop Switch ON/OFF
This switch turns auto stop on or off. When the
automatic stop is enabled, the platform will start
rotating as soon as the tone arm is placed over
the record and will stop rotating when it has
reached the end of the record. Some vinyl
records stop before the end or do not stop when
the end is reached. In this case set Auto-stop to
OFF.
3. 33 / 45 / 78 RPM Switch
This switch controls the RPM of the turntable
platter.
4. Cartridge with Needle
When the turntable is not in use, it is
recommendable to place the removable
protection cover on the stylus.
5. Platter
Place your record here.
6. BT LED
7. Power / Standby LED
8. Power / ON/OFF
Press to turn the device on/off.
9. Repeat
Press to select repeat single track (press once) or repeat full disc/folder (press twice).
10. Mode
Press to switch modes.
11. Previous
Press to play the previous track.
12. Play / Pause
Press to play or pause (depending on the current status).
13. Next
Press to play the next track.
14. Prog / Pair
Prog:
This function allows the CD tracks to be played in a programmed sequence.
NOTE: Program can only be set in STOP mode.
1. Load the CD Disc you wish to program.
2. Make sure the unit is in STOP mode by pressing the STOP button.
3. Press the program / pair button once, the LED display will flash "00" on the LED display.
4. Press previous- or next button until the desired track number is reached.
5. Press the program / pair button again to store the selection.
6. Repeat the (4) to (5) steps until you have entered all the tracks you want to program.
7. To play the stored sequence, press the play / pause button.
8. After all the stored tracks have been played the CD will automatically stop.
Pair:
Press and hold for 3 seconds to disconnect BT.
15. Open / Close
Press to open/close the CD drawer.
16. Stop
Press to stop play.
17. Volume Control
Turn to adjust the master volume.
18. DC IN port
Connecting the 12Volt/DC power adapter.
19. RCA Line output
The audio from a playing vinyl record is sent to this line-level coaxial audio output. This must not be connected to phono
level devices.
20. AUX input
3.5mm(1/8) jack connector for auxiliary input.
21. FM Antenna
22. CD Drawer
23. Dial Knob
24. Dial Scale
4