Suntec Wellness KLIMATRONIC CoolBreeze 4000 SV-RC Mode D'emploi page 13

MOUNTING NOSE OF THE FAN
1. parts identification of the fan nose
1. motor
2. rear guard
3. guard lock nut
4. blade
5. blade cap
6. front guard
7. screw
2. mounting the rear guard.
Mount the rear guard on the Motor and secure
it with the Guard
lock nut.
3. mounting the blade
insert the blade onto the motor shaft. Tighten
the blade with
the blade cap.
4. mounting the front guard
there are two type construtions of fan front
guard, each is assembled according to
followings
mounting the reticular guard
a. mounting the front guard by inserting the hook at the top side of the
front guard over the rear guard. unite them by pressing their sides in order
that the two guards are fixed in the external plastic ring.
b .lock the clip and secure it with the screw.
mounting the spoke guard. hold the Front guard so that the trade mark is
level and the two projections on the
Front guard are centered over the Rear guard. Now push all the safety Clips
firmly into place.
HOW TO USE
Speed control
Speed of a fan is controlled by a key or slider switch . Each is operated according
to followings (1) Operation of
To any of the speed positions (1-2-3), To turn it off .slide switch
Position.
(2) Operation of key switch
To turn on the fan, simply push any of The speed control push buttons (1-2-3), to
turn it off . Push the "o" button.
Oscillation
Push down the oscillation knob and the Fan will oscillate ,pull up the knob, the fan
will not oscillate.
slider switch to turn on the fan simply, slide switch
"O"
to