Power-Saving Mode - Panasonic CF-VDM742U Instructions D'utilisation

Power-saving Mode

If the drive is not accessed for 30 seconds, the drive motor will automatically be shut
down to reduce the power consumption. When the drive is accessed again, the drive motor
is turned on. In this case, reading of the disk data will take approximately 30 seconds.
Information
To play DVD-Video or MPEG2 fi les;
Use "WinDVD" preinstalled in the computer.
Region Code Setting
DVD-Video are allocated to region codes according to where they are sold. To play a
DVD-Video, the player's software and the drive must have the corresponding region code.
e.g.,
For U.S.A. and Canada: "1"
For Europe: "2"
The region code of the drive is not set at purchase. The operation depends on the DVD-
Video that is fi rst played.
• DVD-Video with a specifi c region code:
The drive will automatically be set at the same region code as the DVD-Video.
• DVD-Video with multiple region codes:
[Confi rm Region] appears. Select the region code and click [OK]. Play now begins.
CAUTION
You can change the region code setting up to fi ve times including the initial setting.
Be extremely careful because you cannot change the region code anymore after the
fi fth change, even if you reinstalled the operating system.
Any problem resulting from illegal changing or altering of the region code is the
user's responsibility.
NOTE
[Confi rm Region] appears when the DVD-Video has only one region code and the
drive is set for another region code.
([Confi rm Region] may not appear with some DVD-Video disks. To check the cur-
rent region code and the number of remaining times of changing the code, right-
click on the WinDVD screen and click [Setup] - [Region].)
All manuals and user guides at all-guides.com
E
9