Power-Saving Mode - Panasonic CF-VCW283 Mode D'emploi

Setting a Disc
1
Power on your computer
2
Open the disc tray
Press the eject button and slowly pull out the tray.
NOTE
Before using the drive for the first time, re-
move the protective sheet from the lens area.
The protective sheet inside the drive delays
the opening of the drive by about ten seconds.
This delay is not a problem.
3
Place a disc
1 Place the disc with the label facing upward in the
drive.
2 Push down until the center holder clicks.
<Removing a disc>
Place a finger on the center holder and lift up on the
edge of the disc.
4
Close the disc tray
Close the tray without touching the eject button.
NOTE
If the vibration of the drive is excessively high, use the Setup Utility to reduce the
drive speed by setting it to [Low].
Windows 98
In the following cases, the drive speed may not be set to [Low]. At a time like this,
restart your computer.
• When operation is resumed from the standby or hibernation mode
• When a drive has been installed while the power was still on

Power-saving Mode

If the drive has not been accessed within 30 seconds, the drive motor will automatically shut
down to reduce the power consumption. When the drive is accessed once again, the power
of the drive motor is turned on. However, approximately 30 seconds are required until data
is actually read from the disc.
Label side up
Eject Button
Center Holder
E
7