SPECIFICATIONS — MODEL # 44320
Stage
Zoom Eyepiece
Focuser
Objectives
Illuminator — Top
Illuminator — Bottom
Nosepiece
Imager Resolution
Weight/Dimensions (with batteries)
MAGNIFICATION TABLE
Use the following table to determine the magnification
of the different eyepiece/objective lens combination of your
microscope. For imager magnifications see the chart on
page 5.
SETTING UP YOUR MICROSCOPE
1. Take the Styrofoam container out of the carton.
2. Remove the tape from the Styrofoam container holding the
various parts in place.
3. Carefully remove the microscope and other parts from the
container and set them on a table, desk, or other
flat surface.
4. Remove the plastic bag covering the microscope.
5. Remove the plastic cap from the zoom eyepiece
Fig. 1 (1).
6. Install two AA batteries (user supplied) in the base Fig.
1 (11) of the microscope for the bottom illuminator. See
Figure 3
, showing the battery compartment closed at the
A
back of the microscope. Figure 3
being installed in the compartment (see the inside of the
battery compartment door to locate where the positive (+)
and negative (-) ends of the batteries go. Pull out on the
Plain Stage with metal clips — 74 mm x 70 mm (2.9" x 2.8")
Glass optics — power continuous from 10x to 20x
Coarse focus — dual knobs
All glass optics — see magnification chart for powers
Pen light style
Uses 2AA batteries (user supplied)
Triple with click stop
VGA 640 x 480 pixels
17 oz (482 g) — 5.25" x 3.13" x 9.75" (133 mm x 79 mm x 248 mm)
shows the batteries
B
Objective Lens
10x on Zoom Eyepiece
20x on Zoom Eyepiece
door to open it while holding the base firmly and push
firmly to close it after the batteries are installed.
F
3
IGURE
A
You are now ready to use your microscope for looking at
specimen slides or small objects through the zoom eyepiece!
For using the digital (CMOS) imager, installation and
operating instructions will follow later in this manual.
4x
15x
30x
40x
150x
300x
80x
300x
600x
F
3
IGURE
B
ENGLISH
3
I