Important - Ribimex RIBITECH PRCOMP1/KIT Manuel D'instructions Et D'utilisation

V. OPERATION
5.1- Intended use
- The product is intended for indoor domestic use.
- The product is intended for inflating wheels (tyres, bicycle wheels ...), balloons, mattresses or inflatable
boats, or dusting mechanical parts; using the appropriate accessory within the limits of the tool's working
capabilities.
- Do not use the tool for working on products containing asbestos or other toxic or dangerous materials.
- Do not use for any other purpose not recommended.
- Do not use the tool for unsuitable purposes (e.g. dusting of products containing dangerous substances ...),
or for any use not described in this manual. Any other use different from what is stated in these instructions
may cause damage to the product and represent a serious danger to the user.
- The tool is not intended for artisanal, commercial, professional and / or industrial use.
- Do not use accessories other than those recommended by the manufacturer to avoid a danger.
5.2- Operation
Before operation
Connect the gun to the air hose quick coupler and then the accessory on the gun (8) or connector (13).
Connect the plug into an outlet (230V ~ 50Hz).
Getting started
Set the switch (3) to the ON position (I).
Press the trigger (11) to release the air. The output pressure can also be adjusted using the release valve (12).
The pressure gauge (10) indicates the air pressure, if the pressure is too high, press the release valve (12) to
adjust to the desired pressure.
After each use
Stop the compressor: put the switch in the OFF position (0).
Disconnect the plug from the power outlet.
Release the air from the system.
Only disconnect the accessories once the machine is unplugged and the air has been released.
5.3- Tips:
Always use the handle located on the top of the unit to move or transport it.
Before starting, always make sure that the unit is laying flat on a flat or stable surface.
Never direct the air jet towards people, animals or oneself.
Never spray liquids on the device.
Never exceed the maximum operating pressure.
If the power cable is damaged, it must be replaced by the manufacturer, its after-sales service or a similarly
qualified person to avoid a hazard.
All hoses, fittings, nozzles and / or accessories used must have an operating pressure greater than the
compressor's maximum operating pressure.
IMPORTANT: you should know the pressure required by the devices connected to the compressor.
Overpressure can cause damage to these devices and / or to the compressor and likely to pose a danger to the
user.
DO NOT USE THE COMPRESSOR IF YOU DO NOT CONTROL OR DO NOT KNOW THE
OPERATING MODES OF THE CONNECTED DEVICES.
Page 18 / 31