Publicité
Les langues disponibles
Les langues disponibles
- In the blue circles : screws BHc 5×15
- In the red circle : screw BHc 5×35 to keep tail light in position
- To fit the undertray : to fix it to the threaded fasteners with the BHc 5×15 (big head) screws and the plastic
washers. For the lower fixing points, re-use the original screws : 2 rivets on the side panels and 2 screws on the
lower part.
- Connect the tail light, the blinkers and the number plate light as follows :
Blinkers :
Number plate lighting - the black wire should be connected to the black tail light wire
Tail light :
Leave yellow and blue wires of the provided tail light (wires of integrated indicators).
- Replace the rear fairing, the side panels and the passenger seat.
The whole SUP09 + plate + lighting + blinkers does not be more than 500 g.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* Any deterioration of the parts due to the presence of any excessive load in the undertray will not be guaranteed.
* A few tyres, faithful to ETRTO standards, may be in fact bigger and higher than dimensions engraved on the tyre (until + 10 mm). They may be not compatible with undertrays and rear huggers which we made with original
tyres and whose dimensions correspond to these ones engraved on tyre.
* Harden the rear shock absorber while drivings with load or on dented roads.
- the black wire is – and the yellow one is +
- the white wire should be connected to the white tail light wire
- the black wire should be connected to the green wire on the scooter
- the white wire should be connected to the pink and blue wire on the scooter
- the red wire should be connected to the green and yellow wire on the scooter
For a compliant mounting, refer to enclosed instructions.
Tail light supplied
Silent block with steel spacer
Plastic spacer
Metal number plate bracket
« CAUTION »
Undertray
Publicité
