Setting The Brightness; Setting The Sound Sensitivity; Setting The Sound Activation; Selecting The Transmitter (Camera) - AUDIOLINE Watch & Care V90 Mode D'emploi

Operating the Receiver

Setting the brightness

Press the Menu key.
Press VOL▲ or VOL▼to select
Press ◄ or ► to select the desired brightness.
Press the Menu key.

Setting the sound sensitivity

You can adjust the microphone sensitivity of the transmitter. The higher the sensitivity level, the more
sensitive the transmitter is in detecting sounds for transmitting to the receiver.
Press the Menu key.
Press VOL▲ or VOL▼to select
Press ◄ or ► to select the desired sentitivity (highest sensitivity level:
Press the Menu key.
Note that when the highest sensitivity level (5) is selected then this will override the sound activation
function and the screen on the parent unit will remain active continuously.
The default setting is level 4.

Setting the sound activation

The receiver continuously monitors the sound level in your baby's room. When the sound activation
mode is on, the receiver screen turns on when the transmitter detects a sound.
As long as no sound is detected within 50 seconds, the receiver screen is off to save power. When
your baby starts to cry, the sound activation triggers the receiver screen automatically turns on.
Press the Menu key.
Press VOL▲ or VOL▼to select
Press ◄ or ► to switch the sound activation on ( ) or off ( ).
Press the Menu key.

Selecting the transmitter (camera)

If two or more transmitters (cameras) are registered to your receiver, you can select the active came-
raor start automatic switching (Patrol Mode).
Press the Menu key.
Press VOL▲ or VOL▼to select
Press ◄ or ► to change the active camera (1, 2, 3 or 4) or start the Patrol Mode ( ). If you select
Patrol Mode to view the images, the screen switches to view another transmitter automatically after
some time. The switching is in chronological order: 1...4.
Press the Menu key.

Putting an additional transmitter (camera) into service

The receiver allows you the possibility to register up to four transmitters (cameras) simultaneously,
and to manually change or automatically switch between them.
The delivered camera is already registered with your receiver.
Press Menu/Select.
Press VOL▲ or VOL▼to select
Follow the full instructions that accompany your new transmitter (camera).
.
.
.
.
and press the Menu key.
).
7
GB