Operating the Receiver
Operating the Receiver
a
Attention: Position the transmitter with a minimum distance of 1 m to other electronic devices,
otherwise there is a risk of mutual disturbance. Point the upper section of the transmitter towards the
baby or object you want to monitor. Check that the baby or object is suitably displayed on the
receiver.
Switching the receiver on/off
Press and hold the On/Off button for approx. 3 seconds.
The POWER on/off indicator will flash until the connection to the transmitter (camera) is established.
Then the LED will light constantly and you will see the picture on the screen.
To switch the unit off, press and hold the On/Off button for approx. 3 seconds.
Display icons
Connection status: The more bars that are displayed, the better the connection is.
- The link between the transmitter and the receiver is lost.
- The receiver is searching for a transmitter.
x
Current view status (x = Number of the transmitter that is being viewed: 1...4).
The camera has zoomed in.
Volume is turned off.
Sound activation is on.
Battery status.
Turn on or off the screen / Video/Audio switching
You can turn on or off the parent unit screen without powering off the parent unit to save battery
power. You can still hear sound from the baby unit.
Press the On/Off button briefly.
For switching the display on again press the On/Off button again briefly.
Intercom function
Press and hold the Talk button. The speaker on the transmitter (camera) is turned on and you can
talk to your child or anybody else who is in the same room as the camera. While the Talk button is
being pressed, you cannot hear any noise from the baby's room.
Setting the volume
Press VOL▲ to increase the volume or VOL▼ to decrease the volume. If the volume is set to "zero"
the display shows
Setting the zoom
Press
to zoom in on the image. Press and hold to move the selection: VOL▲ (up), VOL▼
(down), ◄ (to the left) or ► (to the right).
Press
again to deactivate the zoom function.
6
.