Unpacking Instruction; Power Supply - Power Dynamics PV240BT Manuel D'instructions

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
FRONT AND BACKPANEL
1. POWER ON/OFF SWITCH
Press this button to ON/OFF the unit.
2. LED DISPLAY SCREEN
To display the input sources and track time information
3. SD CARD SLOT
Insert your SD Card to play MP3 files.
4. USB PORT
This is the USB port where you insert your USB mass storage device for playing MP3 files.
NOTE: The USB input is only mean to connect to a USB-flash drive. Connecting an MP3 player or computer directly to the
USB-flash drive input will result in the unit failing to play the audio from those devices.
5. CONTROL BUTTONS
A. PREV BUTTON: Use this button to select each of function depending on these three different modes as below.
•
In USB/SD/BT mode, use to select previous track.
•
In FM mode, use to select pervious channel.
•
In FM/BT mode, hold this button will decrease the volume.
B. PLAY/PAUSE BUTTON: Each pressing of the PLAY/PAUSE BUTTON causes the operation to change from play
to pause or from pause to play in the USB/SD mode or BT mode.
•
Presses the PLAY/PAUSE BUTTON one time to auto scan all frequencies from 87.5MHz to 108MHz in
FM mode, the unit will auto store the channels.
C. NEXT BUTTON: Use this button to select each of function depending on these three different modes as below.
•
In USB/SD/BT mode, use to select next track
•
In FM , use to select next channel.
•
In FM/BT hold this button will increase the volume.
D. STOP BUTTON: Use this button to stop the playing of music.
E. REPEAT BUTTON: This button allows you to play the music in repeat mode ( All or Single mode)
ALL All tracks in the USB or SD CARD will be repeated in order without interruption.
SINGLE Repeat the track that was current playing.
F. MODE BUTTON Press this button to select one of play mode with USB/SD mode, FM mode and BT mode,
automatically set in USB/SD mode after turn on the unit, automatically play mp3 files after inserting a USB -flash
driver or SD card.
4