SunWare TX Serie Instructions D'installation page 8

1 Foreword
Congratulations!
You have purchased a high-quality solar module from SunWare
S olartechnik and thus have opted for the highest quality made in
Germany".
T o enable you to enjoy your new solar module for as long s
possible, please read the following information carefully.
If this does not answer any queries you may have sufficiently,
please contact your specialist dealer in the first instance.
O f course, we are also very happy to help as much as we an.
Direct information is available at www.sunware.de
Pack content (Pic. 2):
1 x TX solar module
1 x Instruction manual
1 x Cable plug 2-pin, watertight
1 x Cable socket 2-pin, watertight
1 x Cover cap for socket, watertight
20 x Cable ties, black, UV-stabilised
1 x Locking key for Tenax backing plate
matching Tenax base parts
For modules with more than one wing:
1 x Solar module bag with carry handle
11
2
"
a
c
Important information
This user manual provides important safety instructions that you
should read carefully and follow.
Please retain your original invoice and the original packaging at
least for the period of the warranty.
Further information:
- for optimum performance avoid partial shading where possible
- each TX module wing works as a separate module
- protect module surface from cutting damage
- never carry, pull or fix the TX module by the connection cable
- always fold multi-wing TX modules with cells protected on the
inside ( Pic. 5.1 + 5.2 )
- when stowing never place the cable plug on, or fold into, the
Æ
wings risk of cell breakage
- always fasten TX modules at the textile edges
- do NOT cut or drill through module laminate of the base plate
Æ
loss of warranty
- TX modules must NOT be walked on even if placed on a firm
base
- TX modules must NOT be bent
- TX modules must always be folded along the textile joints
( Pic. 5.3 )
- permissible bending 3cm/1m module length (see below)
- TX modules are NOT suitable for permanent installation on
motor vehicles
Module length of 1m
Solar modules can be bent a maximum of 3%
EN
3 cm max.
12