Declaration Of The Manufacturer; Quick Start - NEC MultiSync LCD195NX Manuel Utilisateur

TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO, DO NOT USE THIS UNIT'S
POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS UNLESS THE PRONGS CAN BE FULLY INSERTED.
REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
CAUTION
RISK OF ELECTRIC SHOCK • DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK). NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL.
This symbol warns user that uninsulated voltage within
the unit may have sufficient magnitude to cause electric
shock. Therefore, it is dangerous to make any kind of
contact with any part inside this unit.
This symbol alerts the user that important literature
concerning the operation and maintenance of this unit
has been included. Therefore, it should be read
carefully in order to avoid any problems.
Contents
Power
User's Cord
Manual
CD-ROM
Audio 15-pin mini D-SUB
Cable male to 15-pin mini
D-SUB male

Quick Start

Figure A.1 Figure A.2
Highest
Stand
Position
Power Cord
Audio In
01_English
WARNING
DVI-D to DVI-D
Cable
management
MultiSync LCD monitor
cover
Macintosh Cable Adapter (not included)
Figure A.3
30˚ Tilt
DVI Cable
D-Sub
DVI
Figure C.1
1

Declaration of the Manufacturer

We hereby certify that the colour monitor MultiSync LCD195NX
(L194F2) is in compliance with
Council Directive 73/23/EEC:
– EN 60950-1
Council Directive 89/336/EEC:
– EN 55022
– EN 61000-3-2
– EN 61000-3-3
– EN 55024
Your new NEC MultiSync LCD monitor box* should contain the
following:
• MultiSync LCD monitor with height adjustable stand
• Power Cord
• Video Signal Cable (15-pin mini D-SUB male to 15-pin mini D-
SUB male)
• Video Signal Cable (DVI-D to DVI-D)
• Audio Cable
• User's Manual
• CD-ROM
• Cable management cover
* Remember to save your original box and packing material to transport or ship
the monitor.
To attach the MultiSync LCD monitor to your system, follow these
instructions:
1. Turn off the power to your computer.
2. For the PC or MAC with DVI digital output: Connect the DVI-D
signal cable to the connector of the display card in your system
(Figure A.1). Tighten all screws.
For the PC with Analog output: Connect the 15-pin mini D-SUB
signal cable to the connector of the display card in your system
(Figure A.2). Tighten all screws.
For the Mac: Connect the MultiSync Macintosh cable adapter (not
included) to the computer. Attach the 15-pin mini
D-SUB signal cable to the MultiSync Macintosh cable adapter
(Figure A.3). Tighten all screws.
NOTE: Some Macintosh systems do not require a Macintosh cable
adapter.
3. Place hands on each side of the monitor to tilt the LCD panel 30-
degree angle and lift up to the highest position (Figure C.1).
4. Connect all cables to the appropriate connectors (Figure C.1).
English-1
1/10/07, 8:38 AM
and marked with
NEC Display Solutions, Ltd.
4-13-23, Shibaura,
Minato-Ku
Tokyo 108-0023, Japan