Ego Power+ ST1500 Guide D'utilisation page 32

Trimmer head will
not advance line.
Grass wraps around
trimmer head and
motor housing.
Line is not cutting
well.
The spool retainer
loosens after it is
fixed in position or
drops while cutting.
32
56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER
◾ ◾
The motor shaft or trimmer
head is bound with grass.
◾ ◾
There is not enough line on
the spool.
◾ ◾
The trimmer head is dirty.
◾ ◾
The line is tangled on the
spool.
◾ ◾
The line is too short.
◾ ◾
Cutting tall grass at ground
level.
◾ ◾
The line-cutting blade on
the edge of the guard has
become dull.
◾ ◾
The trimmer head is worn
out.
◾ ◾
Stop the trimmer, remove the
battery, and clean the motor shaft
and trimmer head.
◾ ◾
Remove the battery and replace the
cutting line; follow the section "LINE
REPLACEMENT" in this manual.
◾ ◾
Remove the battery and clean the
spool, spool retainer and spool base.
◾ ◾
Remove the battery, remove the line
from the spool and rewind; follow
the section "LINE REPLACEMENT" in
this manual.
◾ ◾
Remove the battery and pull the
lines while alternately pressing down
on and releasing the bump knob.
◾ ◾
Cut tall grass from the top down,
removing no more than 8 inches in
each pass to prevent wrapping.
◾ ◾
Sharpen the line-cutting blade with a
file or replace it with a new blade.
◾ ◾
Replace the trimmer head
immediately; follow the section
" REPLACE THE TRIMMER HEAD"
in this manual.