Temperature Control - EAS ELECTRIC VINOTECA EMR44VNI1 Guide D'utilisation

2.2

Temperature control

(The picture above is only for reference. The actual configuration
will depend on the physical product or statement by the distributor.)
Standby button
Light button
Temperature display area of upper room
Temperature display area of lower room
Temperature increase button
Temperature decrease button
Conversion button of function of upper and lower room
Display control
In the case of initial power-up, the whole screen will display relevant
information for 3 seconds and the start-up tone will be uttered,
followed by enabling of normal operation display.
Digital display area: display the fault code in the case of failure and the
set temperature of the corresponding refrigeration chamber in the
case of no failure.
This cooler adopts the touch control of the glass door. Touch
slightly when pressing the keys. It is to be avoided that the area
of the display panel is scratched by the sharp things and it shall
be kept away from the environment of high magnetic field and
high humidity. Otherwise the cooler is possible not to be set
and operate normally.
Standby Function
Press the "Standby" button for 5 seconds to enter/exit the standby
mode.
Light
The internal lamp will be on when the cooler door is opened, and will
be off when the cooler door is closed.
Users can also turn on/off the internal lamp by pressing the Light
button. Once the Light button is activated, the internal lamp will not be
controlled by actions of door opened or closed.
10 V.2