Publicité
Les langues disponibles
Les langues disponibles
Adjusting the Sound Characteristics
1.
Press the
AUDIO
to select the desired adjustment mode
as follows;
BASS 0
TREBLE 0
LOUD OFF (LOUDNESS)
X-BASS 0
L0 R0 (BALANCE)
R0 F0 (FADER)
LE Lo (LEVEL METER)
2.
Rotate the VOL dial to adjust the selected item.
Use the following tables as a guide for adjusting the set-
tings in each mode.
Adjust within 5 seconds after selecting the item. After 5
seconds, the unit returns to previous indication.
Adjustment Range
BASS
BASS –5
BASS 5
TREBLE
TREBLE –5
TREBLE 5
LOUDNESS
LOUD OFF
LOUD ON
X-BASS
X-BASS 0
X-BASS 4
BALANCE
L9 R0(Full left)
L0 R9(Full right)
FADER
R9 F0(Full rear)
R0 F9(Full front)
LEVEL METER
OFF
Lo (Normal)
Tip
Settings for BASS, TREBLE, LOUDNESS and XBASS can
be made to each of the following modes independently:
FM, AM, CD, CD Changer and AUX.
E-4
BPV660(EN)_body
4
Enhancing the bass sound
For extended bass centered @ 72Hz, Blaupunkt's X-BASS
function can be set for either each band and CD mode.
You can select :
• X-BASS 1 : Enhanced BASS level (low).
• X-BASS 2 : Enhanced BASS level (Middle).
• X-BASS 3 : Enhanced BASS level (High).
• X-BASS 4 : Enhanced BASS level (Very high).
• X-BASS 0 : No BASS enhanced.
Press the
AUDIO
to display the " X-BASS " on the display win-
dow. Each time you rotate the VOL dial, the current mode
appears on the display window and the mode change as fol-
lows:
X-BASS 0 (No display)
X-BASS 1
X-BASS 2
X-BASS 3
X-BASS 4
Note
Reduce XBASS level if your combination of speakers and add-
on amplifiers sound distorted at the preferred sound level.
Level Meter Sensitivity selection
The sensitivity of the level meter display can be switched.
You can select :
• OFF (No indication)
• Low
: Normal (Low) sensitivity.
• High
: High sensitivity.
1.
Press the
AUDIO
to display the " LE Lo " on the display
Hi (High)
window.
2.
Rotate the VOL dial to select the desired meter sensitiv-
ity.
:
OFF
:
Lo
:
Hi
Switching the Source (Selecting auxiliary
input)
You can connect auxiliary equipment (Portable cassette
player, etc) to this radio via optional AUX-IN cable. (See page
9)
CD
Each time the
is pressed, the operation source will
change over as shown below;
RADIO
CD
CD changer or AUX
Press the
BAND
to return to tuner mode.
Note
If the
CD
button is pressed when no CD has been loaded
into the unit, The CD mode will skip to the CD changer mode
or AUX mode.
Also, if the CD changer is not connected, the system will move
across to the AUX mode regardless of whether auxiliary equip-
ment is connected or not (" AU " will be displayed.)
It is not possible to switch to the AUX mode when the CD
changer is connected.
1/22/02, 10:48 AM
Publicité
