Kawasaki K-SSCM 1200 Notice Originale page 19

bolt it into position (B14).
Set the angle stop (6) to the required angle and
guide the cutting disc slowly and evenly through
the workpiece.
Change the cutting disc
- Pull the mains plug.
- Wear safety gloves.
- Undo the three screws on the saw blade guard
(10) and remove the guard (A) (B11).
- Place the ring wrench (20) on the ange nut (A)
(B15).
- Place the shaft wrench (21) on the motor shaft
(B) (B15).
- Undo the ange nut by turning it anti-clockwise
(A) (B15).
- Remove the ange nut, external ange and cut-
ting disc.
- Fit the new cutting disc following the above
instructions in reverse (B16).
Important: Check the direction of rotation of the
cutting disc (5).
- Fit the saw blade guard (19) again using the
three screws.
Maintenance
Depending on the frequency of use, the pump
(14) must be cleaned at regular intervals.
- Take the pump (14) out of the water tank.(B8)
- Remove the lter (A) and the pump impeller
cover by turning them.
- Pull out the impeller and clean all the parts
under running water. Remove any deposits.
Cleaning
- Empty and rinse out the water tank at regular
intervals.
- Keep the motor ventilation grille clean at all
times.
- Treat all the moving parts at regular intervals
All manuals and user guides at all-guides.com
with biologically degradable grease or oil.
- Do not treat plastic covers with solvents.
- Use only damp cloths and brushes for cleaning
purposes.
Technical data
Mains voltage:
Motor rating:
Speed:
Cutting disc:
Cutting depth:
Cutting length:
Table size:
Weight:
L
pA
L
WA
K=3 dB(A)
a : 3,6 m/s
h
K=1,5 m/s
IP54
Repairs
Only use accessories and spare parts recommen-
ded by the manufacturer. If the equipment should
fail some day in spite of our quality controls and
your maintenance, only have it repaired by an
authorised electrician.
Environmental Protection
Do not simply dispose of the equipment, accesso-
ries and packaging in the rubbish bin, but bring it
for environmentally sound recycling.
The small e ort involved in this is for the bene t
of our environment.
230 V~/50 Hz
1200 W S2 10 min.
2950 rpm
250 x 25,4 mm
52 mm at 90°, 46 mm at 45°
1200 mm
1260 x 468 mm
64 kg
=93 dB(A)
=106 dB(A)
2
2
19