Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Making ice cubes
Fill the ice - cube tray 3/4 full with water and place
it in the freezer. Loosen frozen trays with a spoon
handle or a similar implement; never use sharp-
edged objects such as knives or forks.
Defrosting
A) Fridge compartment
The fridge compartment defrosts automatically.
The defrost water runs to the drain tube via a
collection container at the back of the appliance.
Check that the tube is permanently placed with its
end in the collecting tray on the compressor to
prevent the water spilling on the electric
installation or on the floor (Item 6).
B) Freezer compartment
The NO FROST type defrost is compleetly
automatic.
No intervention from your side is requiered. The
water is colected on the compressor tray.
Due the heat of the compressor the water is
evaporated.
Never use hairdryers, electrical heaters or
other such electrical appliances for defrosting.
Warnings!
The fans inside the freezer and fresh food
compartments circulates cold air.
Never insert any object through the guard.
Do not allow children to play with the fresh food
andfreezer fan.
Never store products that contain inflammable
propellant gas (e.g. dispensers, spray cans etc.)
or explosive substances.
Don't cover the shelves with any protective
materials, which may obstruct air circulation.
Do not allow children to play with the appliance or
tamper with the controls.
Do not obstruct the fan guards to ensure that you
obtain the best possible performance from your
appliance (Item 7 and Item 8).
Warning!
Your appliance is fitted with a circulating fan which
is essential for the performance of the refrigerator.
Please ensure the fans are not blocked (stopped)
or impaired by food or packaging. Blocking
(stopping) or impairing the fan can result in an
increase of the internal freezer temperature
(Thawing).
Replacing the interior light bulb
To change the Bulb/LED used for illumination of
your refrigerator, call your Authorised Service.
The lamp(s) used in this appliance is not
suitable for household room illumination.
The intended purpose of this lamp is to assist
the user to place foodstuffs in the refrigerator /
freezer in a safe and comfortable way.
The lamps used in this appliance have to withstand
extreme physical conditions such as temperatures
below -20°C.
Cleaning and care
1. We recommend that you switch off the appliance
at the socket outlet and pull out the mains plug before
cleaning.
2. Never use any sharp instruments or abrasive
substances, soap, household cleaner, detergent or
wax polish for cleaning.
3. Use luke warm water to clean the cabinet of the
appliance and wipe it dry.
4. Use a damp cloth wrung out in a solution of one
teaspoon of bicarbonate of soda to one pint of water
to clean the interior and wipe it dry.
5. Make sure that no water enters the temperature
control box.
6. If the appliance is not going to be used for a long
period of time, switch it off, remove all food, clean it
and leave the door ajar.
7. We recommend that you polish the metal parts of
the product (i.e. door exterior, cabinet sides) with a
silicone wax (car polish) to protect the high quality
paint finish.
8. Any dust that gathers on the condenser, which is
located at the back of the appliance, should be
removed once a year with a vacuum cleaner.
9. Check door seals regularly to ensure they are
clean and free from food particles.
10. Never:
• Clean the appliance with unsuitable material; eg
petroleum based products.
• Subject it to high temperatures in any way,
• Scour, rub etc., with abrasive material.
11. Removal of dairy cover and door tray:
• To remove the dairy cover, first lift the cover up by
about an inch and pull it off from the side where there
is an opening on the cover.
• To remove a door tray, remove all the contents and
then simply push the door tray upwards from the
base.
12. Make sure that the special plastic container at the
back of the appliance which collects defrost water is
clean at all times. If you want to remove the tray to
clean it, follow the instructions below:
• Switch off at the socket outlet and pull out the mains
plug
• Gently uncrimp the stud on the compressor, using a
pair of pliers, so that the tray can be removed
• Lift it up.
• Clean and wipe it dry
• Reassemble, reversing the sequence and
operations
13. To remove a drawer, pull it as far as possible, tilt it
upwards and then pull it out completely.
Repositioning the door
Proceed in numerical order (Item 10).
9
Instruction for use
Publicité
Table des Matières
