Axis P5522-E Guide D'installation page 7

AXIS P5522-E Installation Guide
Install the hardware
Prepare for installation
Read all the instructions before preparing to install the network camera since several installation
preparation steps require removing the top cover and would benefit from being completed together.
The sunshield must be removed to install/remove an SD card, see Install an SD card (optional), on
page 8.
• Follow the instructions Remove the protective packaging, below to remove the protective
packing before installing the camera.
• The network camera is supplied with a clear transparent cover and a smoked transparent
cover. If required, follow the instructions Replace the clear/smoked dome cover (optional),
below to replace the dome cover.
• A standard or high capacity SD card (not included) is required to store images locally in the
network camera. Follow the instructions Install an SD card (optional), below to remove the
dome cover and install an SD card.
Remove the protective packaging
1. Loosen the 4 top cover screws and remove the top cover, see illustration on page 6.
2. Remove the protective packaging.
3. If replacing the clear/smoked dome cover or installing an SD card, refer to the instructions
Replace the clear/smoked dome cover (optional) and Install an SD card (optional), on page 8.
4. Put the top cover back in its original position and fasten the screws.
Protective packaging
Page 7