Publicité
Les langues disponibles
Les langues disponibles
Safeguards
Please read through this Installation Guide carefully before installing the product. Keep the Installation Guide
for further reference.
CAUTION!
•
When transporting the Axis product, use the original packaging or equivalent to prevent damage to the
product.
•
Store the Axis product in a dry and ventilated environment.
•
Avoid exposing the Axis product to vibration, shocks or heavy pressure and do not install the camera on
unstable brackets, unstable or vibrating surfaces or walls, since this could cause damage to the product.
•
Only use handtools when installing the Axis product, the use of electrical tools or excessive force could
cause damage to the product.
•
Do not use chemicals, caustic agents, or aerosol cleaners. Use a damp cloth for cleaning.
•
Only use accessories and spare parts provided or recommended by Axis.
•
Do not attempt to repair the product by yourself, contact Axis or your Axis reseller for service matters.
IMPORTANT!
•
This Axis product must be used in compliance with local laws and regulations.
Battery replacement
This Axis product uses a 3.0V CR2032 Lithium battery as the power supply for its internal real-time clock (RTC).
Under normal conditions this battery will last for a minimum of 5 years. Low battery power affects the
operation of the RTC, causing it to reset at every power-up. A log message will appear when the battery needs
replacing. The battery should not be replaced unless required!
If the battery does need replacing, please contact www.axis.com/techsup for assistance.
•
Danger of Explosion if battery is incorrectly replaced.
•
Replace only with the same or equivalent battery, as recommended by the manufacturer.
•
Dispose of used batteries according to the manufacturer's instructions.
Cleaning of dome cover
•
Be careful not to scratch or damage the dome cover. Do not clean a dome cover that looks clean to the eye
and never polish the surface. Excessive cleaning can damage the surface.
•
For general cleaning of a dome cover it is recommended to use a non-abrasive, solvent-free neutral soap or
detergent with water and a soft cloth. Rinse well with clean lukewarm water. Dry with a soft cloth to pre-
vent water spotting.
•
Never use harsh detergents, gasoline, benzene or acetone etc. and avoid cleaning in direct sunlight or at
elevated temperatures.
Publicité
