Elevator Mode - Eden accessIT OUTFX V2-AI Notice Technique

OUTFX V2-AI – Notice technique / Technical Manual
p.18/18
Creating an automatic operation:
Click on the Technical tab, then on the Site Configuration option. Next click on the control unit to which
your OUTFX V2-AI board is connected, then on "Create an automatic operation."
In the list of actions, you will now find all the outputs, which you can then control.
c) Elevator mode
To use your OUTFX V2-AI board in elevator mode, you must firstly create an output group. Refer to
section a. In this group, check all the relays that you wish to activate when a badge is swiped.
This output group will appear in your access groups. Modify your various access groups by selecting for
each reader, the group of outputs to use to control your elevator.