Cabling The Board Outfx V2-Ai With A Access-It Unit - Eden accessIT OUTFX V2-AI Notice Technique

OUTFX V2-AI – Notice technique / Technical Manual

1) Cabling the board OUTFX V2-AI with a ACCESS-IT UNIT

Note :
You can connect up to 5 OUTFX V2-
AI on to your ACCESS-IT UNIT. Be careful
to configure the address switches.
(?) Data sheet:
recommended
0.6 mm
2 pairs recommended
Be sure to use the same pair for A and B
Be sure to separate the supply from the RS485 bus
Characteristic: Sensitive connection
Screen: Recommanded
To reach 1,200 m, you must fit a 220
network (see above).
Note: The total length must not exceed the recommended distance.
Power supply 12Vdc
resistor between points A and B at each end of the
p.14/18