Using Outputs - Eden accessIT OUTFX V2-AI Notice Technique

OUTFX V2-AI – Notice technique / Technical Manual
p.17/18
b) Using outputs
To pilot the outputs of your OUTFX V2-AI board, two possibilities are available:
o Output group: used in an automatic operation, using this group allows you simultaneous control over
all selected relays.
o Classic output: these outputs are available in the actions of automated operations.
Creating an output group:
Click on the Technical tab, then on the Site Configuration option. Next click on the control unit to which
your OUTFX V2-AI board is connected, then on "Create an output group." Then check all the boxes of
the relays you wish to group together.
In your automated operation, select the group of outputs that you have just created: