Publicité
Les langues disponibles
Les langues disponibles
EG 0332
DRILL Ømax 25mm 750W 220V + VICE
3. Drilling in metal: Use clamps to hold the work at any time, especially when breaking through the stock. If piece
is whirled out of the operator's hand, he may be injured, in any case, the drill will be broken when the work strikes
the column.
4. The work must be clamped rmly while drilling: Any tilling, twisting results nit only in a rough hole, but also
increases drill breakage. For at work, lay the piece on a wooden base and clamp it rmly down against the table
to prevent it from turning. If the piece is or irregular
shape and cannot be laid at on the table, it should be
securely blocked and clamped.
5. The chuck shall be securely fastened to the spindle and so that it can't separate from spindle.
6. Remove key from chuck after adjustment.
7. The tool is to be disconnected from the power supply while the motor is being mounted, connected, or
reconnected.
8. The set screws of head frame should be screwed tightly before using this machine.
9. Fasten base to oor or worktable before using the drill press.
10. Use only the chuck key provided by the manufacturer or a duplicate of it. This chuck is spring loaded to prevent
chuck key from remaining in chuck during operation of drilling.
WARNING: only use grounded plugs for this device.
Publicité
