Publicité
Les langues disponibles
Les langues disponibles
EG 0332
DRILL Ømax 25mm 750W 220V + VICE
OPERATION
1. Installing Drills:
Insert drill into chuck jaws about 1" (25.4mm) long. When using a small drill does not insert it so far that the jaws
touch the arbor of the drill. Make sure that the drill is centered in the chuck before tightening the chuck with the key.
2. Positioning Workpiece:
Always place a piece of wood (or plywood ...) on the table. This will prevent "splintering" or making a heavy hurt
on the underside of the workpiece as the drill breaks through. The wood must contact the left side of the column.
3. Using Vise:
For small workpiece that cannot be clamped to the table, use a drill press vise. The vise must be clamped or bolted
to the table.
MAINTENANCE
• Frequently blow out any dust that may accumulate inside the motor.
• A coat of automobile type wax applied to the table and column will help to keep the surfaces clean.
• If the power cord is worn, cut, or damaged, have it replaced immediately.
• Lubrication: All of the ball bearings are packed with grease at the factory. They require to further lubrication.
However, periodically lubricate the gear and rack table elevation mechanism, the splines (grooves) in the spindle,
and the rack (teeth on the quill).
SECURITY
1. To reduce the risk of injury, the user must read and understand the operator's manual before using this product.
2. Never dismantle the protective shields and maintain them in good condition.
3. Guard against electrical shock by preventing body contact with grounded surfaces. Please make sure that your
electrical device is connected to grounding type receptacle.
4. Remove adjusting keys and wrenches. Form the habit of checking to see that keys and adjusting wrenches are
emoved from tool before turning it on. Always check that no tools stay close to the grinder.
5. Keep work area clean. Cluttered areas and benches invite accidents.
6. Do not use in dangerous environments. Do not use power tools in damp or wet locations or expose to rain.
Keep the work area well lit.
Publicité
