CLAS EG 0332 Mode D'emploi page 10

EG 0332
DRILL Ømax 25mm 750W 220V + VICE
A – Main parts:
1. Head Assembly (1 pc)
2. Column with ange (1 pc)
3. Arm of table and bracket (1 pc)
4. Table (1 pc)
5. Base (1 pc)
B – Accessories (separate box):
1. Chuck + Key (1 set)
2. Arbor + Wedge (1 set)
3. Feeding handles + Knobes (1 set)
4. Height adjusting handles + table bracket (1 set)
5. Clamp bolt, table bracket (1 pc)
6. Clamp bolt, table arm (1 pc)
7. Knob and screw, upper pulley cover (4 pcs)
8. Screws and washers, ange (4 sets)
9. Allen wrenches (3mm, 5mm)
ASSEMBLY
1. Assembly the column:
• Place column assembly on base and align holes in column support with holes in base.
• Secure the column with the four bolts and washers provided.
2. Install table bracket:
• Take off collar and rack.
• Install table bracket together with rack.
• Install collar and x it rmly.
3. Install bracket handle and clamp bolt:
• Fix handle with attached set screws.
• Install clamp bolt to x the table bracket.
4. Install table and clamp with bolt.
5. Attach the head assembly:
• Carefully put the head assembly over column and slide it onto column into position. Align head frame with table
and base.
• Fix set screws in right side of head to lock head into position then tighten with Allen wrench.
6. Install the feeding handles:
• Screw knob on each feeding handle.
• Install them into hub of pinion shaft.