CLAS EG 0332 Mode D'emploi page 13

EG 0332
DRILL Ømax 25mm 750W 220V + VICE
7. Keep children and visitors away. All visitors should keep a safe distance from work area.
8. Observe the maximum output/capacity of the grinding machine (see nameplate); do not subject it to overloads.
9. Don't force the tool to do a job it was not designed for. Don't use it for a purpose not intended.
10. Please dress properly : do not wear loose clothing, gloves, neckties, or jewelry. They can get caught and draw
you into moving parts. Nonskid footwear are recommended.
11. Wear protective glasses, and a dust mask. Respect the standard working safety rules.
12. Use clamps or a vise to hold work when practical. It's safer than using your hand and frees both hands to
operate tool.
13. Ensure safe footing when operating the bench grinder. Always make sure you have good balance.
14. To be ef cient and work as designed, your tools should be kept sharp. Dull tools can cause accidents. Please
respect these instructions for lubricating and maintaining the bench grinder.
15. Unplug the tool before operating any maintenance or replacement.
16. Always use genuine parts and respect the instructions. Do not use any attachments or accessories not
recommended by the manufacturer of this tool. It may cause serious personal injuries.
17. Avoid any accidental start: Ensure that switch is in the OFF position before plugging in.
18. Never stand on the bench grinder.
19. Inspect the bench grinder for visible defects. Have damaged, missing, or failed parts replaced or repaired
before resuming operation.
20. Never let the tool working alone and always unplug it when not in use. If you must leave the working area,
please wait until the wheel stops completely.
Safety rules relative to drill presses operation
1. Caution: This drill press is intended for use only with drill bits. The use of other accessories may be hazardous.
2. Correct drilling speeds: Factors which determine the best speed to use in any drill press operation are; Kind of
material being worked, size of hole, type of drill or other cutter, and quality of cut desired. The smaller the drill, the
greater the require RPM. In soft materials, the sped should be higher than for hard metals.