Beamz ILLUSION 1 Manuel D'instructions page 7

FIXTURE TIME
To display the fixture's operating hours counter, select "HOUR" and press ENTER. The display will show the number of hours
the fixture has been in operation since manufacture. Press MENU to exit.
FIRMWARE VERSION
To display the fixture's current firmware version, select "UER" and press ENTER. The display will show the version of firmware
in the fixture. Press MENU to exit.
RESET
The fixture resets its motors each time you power it on, but you can also reset the fixture motors manually from the control panel
and by DMX. To carry out a manual reset from the control panel, scroll to RESET and press ENTER to reset the fixture, or press
MENU to exit without resetting. A reset takes approx. 20 seconds. After this, the fixture returns to its state before the reset.
The fixture motors can also be reset by DMX using the Special Function channel.
HOME POSITION ADJUSTMENT (OFFSET MENU)
If the fixture head does not return to the correct home position even after a reset, you can adjust the home position by defining
offsets.
To make the adjustment from the control panel:
1. Reset the fixture motors as described above.
2. While still in menu mode, press and hold ENTER for at least 3 seconds to enter Offset mode.
3. Use the DOWN and UP buttons up to choose PAN or TILT function to adjust.
4. Use the DOWN and UP buttons to adjust the effect's home position.
5. Press ENTER to save your selection (or press MENU to exit without saving any changes).
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding
can cause greater accumulation of dirt on the unit's optics.
•
Make sure the area below the installation place is free from unwanted persons during servicing
•
Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any deformation
•
The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is
detected
•
In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be cleaned
monthly.
•
The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.
•
Clean with soft cloth using normal glass cleaning fluid.
•
Always dry the parts carefully.
•
Clean the external optics at least every month. Clean the internal optics at least every 30/60 days.
ATTENTION: We strongly recommend internal cleaning to be carried out by qualified worker!
7