After Use - Termozeta SUPER Mode D'emploi

ENGLISH
hair along the nape of the neck. Comb
the hair making sure there are no irregular
lines.
Finish off the sideburns and the line around
the nape of the neck.
See figure L for an example of a cut
indicating the comb accessories to use
for the various parts of the head.

AFTER USE

Set the ON/OFF switch (4) to OFF (0) and always take the plug out of
the outlet when you have finished. Clean the appliance and slip the
safety guard over the blades before putting it away.
CLEANING
WARNING!
Before carrying out any cleaning operation, always disconnect the plug
from the power outlet.
Before putting the appliance away and anyhow after each cut, it is
advisable to clean the blades so that you will always get good results,
cut after cut, and preserve the appliance in
perfect working condition.
With the appliance still switched on, move
the blade control lever (fig. C) rapidly from
down to up a few times. This simple
operation, repeated every time you use it,
will help you to keep the blades clean from
residual hair. If this is not enough, unplug
from the outlet and proceed as follows:
- remove the blades by unscrewing the
screws (fig. M) making sure to handle them carefully as they are very
sharp
L
C
C1
C2