Rowenta POWERLINE CYCLONIC RH7755IA Mode D'emploi page 15

HEPA filters (high efficiency particulate air filters, namely high efficiency filters for air-borne par-
ticle filters) make it possible to hold back the finest particles. Thanks to the HEPA filter, spent air
in the room is cleaner than vacuumed air.
IMPORT NT
lways switch off and disconnect your vacuum cleaner before servicing or cleaning. Check and clean
regularly your whole vacuum cleaner and the different filters.
TTENTION
Never use your vacuum cleaner without the filtration system (microfilter and filter).
1 • Cleaning the dust container (5)
Quick emptying
When the dust container (5) is full, remove the cover from the vacuum cleaner
the dust container (5) by sliding it slightly downwards
press the button marked "Push" to tip the emptying flap down, then empty out the contents of the
(Fig. 14)
container
the vacuum cleaner
Complete cleaning
The container assembly (5) requires regular cleaning.
Remove the cover from the vacuum cleaner
it slightly downwards
then the HEP filter (5b3).
Then remove the foam filter (5b2) and the separator (5b1).
Place the receptacle/dust container (5a) and separator (5b1) under warm water, then leave it to dry or
wipe it with a dry cloth
For cleaning the foam filter (5b2) : Please refer to Section 2 – CLE NING THE FO M FILTER. For clea-
ning the HEP filter (5b3) : For information on servicing filters, please refer to Section 3 – CLE NING
THE HEP FILTER.
Once dry, refit the dust container (5) elements, then refit the complete assembly onto the vacuum
(Fig. 16)
cleaner .
Refit the vacuum cleaner cover (7).
2 • Cleaning the foam filter (5b2)
The foam filter (5b2) should be cleaned after every use, using warm soapy water
leave to dry for at least 12 hours before refitting.
n additional foam filter is supplied with your vacuum cleaner so that you can continue to use your
vacuum cleaner while the original foam filter is drying.
3 • Cleaning the HEPA filter
Your vacuum cleaner is fitted with a HEP filter (5b3).
If you notice your vacuum cleaner losing power, then we recommend that you clean the HEP filter to
retain vacuum performance:
- remove the cover from the vacuum cleaner
- remove the dust container by sliding it slightly downwards
ner cap (5c)
(Fig. 19-20-21)
- pull out the HEP
Replace the HEP filter inside the dust container cap, refit the dust container elements, then refit the
complete assembly onto the vacuum cleaner. Refit the vacuum cleaner cover (7).
* Depending on model
(Fig. 15)
. Close up the flap
(Fig. 16)
.
(Fig. 13)
. Then separate each element: Remove the dust container cap (5c)
(Fig. 17)
.
filter and tap it lightly over a waste container
(Fig. 13)
. Place it over a waste container and
and refit the dust container, then refit the cover onto
(Fig. 12)
. Then remove the dust container (5) by sliding
(Fig. 12)
(Fig. 13)
11
(Fig. 12)
then remove
(Fig. 18)
. Rinse and
then remove the dust contai-
(Fig. 22)
EN